Inside of KST MS565 & MS325 hall sensor servos.


Grease is well applied.

No insulation pad on bottom case, so I added some kapton tape(MS325 is too).

Two 8-pin FETs, like BK DS-5005HV servo.

Two 3-pin FETs, BK DS-3001HV has four FETs.

Three red wires for hall sensor.

The motor is well tied up to middle case.

Trackback 0 And Comment 2
  1. lee jae hyuk 2017.09.03 19:12 신고 address edit & del reply

    good servo. i like it!!

    • vcsel 2017.09.11 01:39 신고 address edit & del

      Thank you for certify it! :-)